CRB360/430F1S F1 Clutch Release Bearing (360/F430)

CRB360/430F1S F1 Clutch Release Bearing (360/F430)

(For F1 equipped cars only)

A vastly improved throw-out bearing from Hill Engineering. This part is a substitute item for 201024 and made with considerably higher tensile aluminum. On OEM bearings, the casting near the rear seal groove has a tendency to blow out causing loss of clutch & fluid loss. Such failure is far less likely with this bearing, as it has been made to the exacting standards of Hill Engineering.   Includes seals 170416, 172970, 172972, 181828, 154507, 181836 pre-fitted. 

We strongly recommend the addition of the rolled steel stop-pin, because the pin in your previous release bearing has likely corroded and become nearly impossible to remove cleanly.   A new roll pin is available here:  14158570

This bearing can be used on the following F1 and Cambriocorsa vehicles:

360 (Modena, Spider, Challenge Stradale)
F430 (Coupe, Spider, Scuderia, Scuderia 16M)
599GTB, F430 (Coupe, Spider, Scuderia)
Maserati 4200 (Coupe/Spider)
Maserati Quatrroporte (2005-2007)

This bearing is for F1 equipped cars only. If you have a 6-speed 360, F430 or 599, please see bearing CRB360/430MS .  

Part CRB360/430F1S

/ Each