CRB360/430F1S F1 Clutch Release Bearing (360/F430)
CRB360/430F1S F1 Clutch Release Bearing (360/F430)
(For F1 equipped cars only)
A vastly improved throw-out bearing from Hill Engineering. This part is a substitute item for 201024 and made with considerably higher tensile aluminum. On OEM bearings, the casting near the rear seal groove has a tendency to blow out causing loss of clutch & fluid loss. Such failure is far less likely with this bearing, as it has been made to the exacting standards of Hill Engineering. Â Â Includes seals 170416, 172970, 172972, 181828, 154507, 181836Â pre-fitted.Â
We strongly recommend the addition of the rolled steel stop-pin, because the pin in your previous release bearing has likely corroded and become nearly impossible to remove cleanly.  A new roll pin is available here: 14158570
This bearing can be used on the following F1 and Cambriocorsa vehicles:
360 (Modena, Spider, Challenge Stradale)
F430 (Coupe, Spider, Scuderia, Scuderia 16M)
599GTB, F430 (Coupe, Spider, Scuderia)
Maserati 4200 (Coupe/Spider)
Maserati Quatrroporte (2005-2007)
This bearing is for F1 equipped cars only. If you have a 6-speed 360, F430 or 599, please see bearing CRB360/430MS . Â
/ Each
This item is used in the following applications:
Contact us about use in cars not listed above.
* Quantity shown indicates the number of pieces used in the diagram.