CRB355F1S F355 F1 Clutch Release Bearing (F1)

CRB355F1S F355 F1 Clutch Release Bearing (F1)

(For F1 cars only)


A vastly improved F355 clutch throw-out bearing from Hill Engineering. This part is a substitute item for 170182 and made with considerably higher tensile aluminum. On OEM bearings, the casting near the rear seal groove has a tendency to blow out causing loss of clutch & fluid loss. Such failure is far less likely with this bearing, as it has been made to the exacting standards of Hill Engineering.

This bearing includes seals 170193, 170194, 170195, and 170196 pre-fitted. If you need additional seals, please contact us.

OH.... and if you need a new support flange, the F355 F1 uses a different version than the other vehicles.  We have the F355 F1 flanges (also from Hill Engineering) available here:  173970

Never replace another blown (and inferior) Ferrari thrust bearing again!

This bearing is for F1 equipped cars only. If you have a 6-speed F355, please see bearing: CRB355MS

Part CRB355F1S

/ Each