178331 T/O BEARING 360
178331 T/O BEARING 360
T/O BEARING
We strongly advise the purchase of a vastly better thrust bearing from Hill Engineering.
A vastly improved 360 (Modena, Spider, Challenge Stradale) and 599GTB clutch throw-out bearing from Hill Engineering. This part is a substitute item for 178331/201024 and made with considerably higher tensile aluminum. On OEM bearings, the casting near the rear seal groove has a tendency to blow out causing loss of clutch & fluid loss. Such failure is far less likely with this bearing, as it has been made to the exacting standards of Hill Engineering.
This bearing includes seals 170416, 170416, 172972, 154508, 154507, 154551 pre-fitted. If you need additional seals, please contact us.
Contact us if you have any questions about this item.
If you have a 6-speed 360 or 599, please see bearing: CRB360-MS
If you have an F1 equipped 360, Stradale, or 599, please see bearing: CRB360F1-MS
This item is used in the following applications:
CarVehicle | *Qty*Quantity | TblTable | LocLocation | Where Used |
---|---|---|---|---|
360 Modena | 1 | 28 | 72 | CLUTCH AND CONTROLS -VALID FOR F1- |
360 Modena | 1 | 27 | 51 | CLUTCH AND CONTROLS -NOT FOR F1- |
360 Spider | 1 | 27 | 51 | CLUTCH AND CONTROLS -NOT FOR F1- |
360 Spider | 1 | 28 | 72 | CLUTCH AND CONTROLS -VALID FOR F1- |
360 Spider | 1 | 28 | 12 | CLUTCH AND CONTROLS -VALID FOR F1- |
ENZO | 1 | 21 | 40 | CLUTCH CONTROLS |
ENZO | 1 | 21 | 8 | CLUTCH CONTROLS |
Contact us about use in cars not listed above.
* Quantity shown indicates the number of pieces used in the diagram.